Displaying vpls extended counters – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 515
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
491
53-1003031-02
Displaying VPLS extended counters
3
The on option enables extended counters for a particular VPLS instance. The off option disables
extended counters for a particular VPLS instance.
Displaying VPLS extended counters
When extended counters are enabled for a particular VPLS instance either by default or explicit
configuration, the user can display the number of bytes and packets received and sent on a
particular endpoint or all the endpoints of that particular VPLS instance. The counters are
displayed whether or not the per-VLAN, port, and priority-based accounting mode is enabled at the
global configuration level.
When the per-VLAN, port, and priority-based accounting mode is enabled at the global
configuration level, the following output is displayed for the show mpls statistics vpls
extended-counters command.
Brocade# show mpls statistics vpls 10 extended-counters vlan 10 ethernet 3/2
VPLS Extended Counters (only applicable for G2 modules):
VPLS Name: test, VPLS Id: 10
VPLS Vlan: vlan 10
Interface
RxPkts TxPkts
RxBytes TxBytes
eth 3/2
4841670
4841670 2595135120 2595135120
p0
4841670
4841670
2595135120
2595135120
p1
0
0
0
0
p2
0
0
0
0
p3
0
0
0
0
p4
0
0
0
0
p5
0
0
0
0
p6
0
0
0
0
p7
0
0
0
0
When the per-VLAN, port, and priority-based accounting mode is disabled, the following output is
displayed for the show mpls statistics vpls extended-counters command.
Brocade# show mpls statistics vpls 10 extended-counters vlan 10 ethernet 3/2
VPLS Extended Counters (only applicable for G2 modules):
VPLS Name: test, VPLS Id: 10
VPLS Vlan: vlan 10
Interface
RxPkts TxPkts RxBytes TxBytes
eth 3/2
4841670 4841670 2595135120 2595135120
Syntax: show mpls statistics vpls [vpls-name | vpls-id [extended-counters [[vlan vlan-id] [ethernet
port-id]]]]
The vpls-name parameter specifies the configured name for a VPLS instance.
The vpls-id parameter specifies the ID of a VPLS instance.
The extended-counters keyword enables the extended counters for a particular VPLS instance.
The vlan vlan-id parameter specifies the ID of the configured VLAN.
The ethernet port-id parameter specifies the port ID of the interface for which the user wants to
display the counters.