Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 407)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 383
53-1003031-02
rsvp-hello disable
2
rsvp-hello disable
Disables RSVP Hello on an mpls-interface.
The [no] function of this command enables RSVP-TE Hello on the mpls-interface where it is
executed.
Syntax [no] rsvp-hello disable
Parameters disable
Disables RSVP-TE Hello protocol on this interface.
Command
modes
This command operates at MPLS interface configuration mode.
Usage guidelines The main use case of this is when you want the Hello parameters to be stored on the
mpls-interface level but do not want the mpls-interface to participate in RSVP Hello exchange.
CAUTION
When disabling RSVP hello, please disable it on both sides of the link at the same time to avoid
bringing down all the RSVP sessions going over that link.
History
Release Command history
Multi-Service NetIron Release 05.6.00 This command was introduced.
Related
commands
None.