Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 444)

420 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying LDP information
2
The following example displays a MTU mismatch for VC ID of 100 where the VC label received from
the remote peer is in a Retained state instead of an Installed state.
Brocade# show mpls ldp fec vc 100
FEC_CB: 0x293916f8, idx: 3, type: 128, pend_notif: None
State: current, Ingr: Yes, Egr: Yes, UM Dist. done: Yes
VC-Id: 100, vc-type: 4, grp-id: 0
Local-mtu: 2000, remote-mtu: 1500, MTU enforcement: enabled
Downstream mappings:
Local LDP ID Peer LDP ID Label State CB
10.128.128.28:0 10.125.125.1:0 800000 Retained 0x29391328(-1)
Upstream mappings:
Local LDP ID Peer LDP ID Label CB
10.128.128.28:0 10.125.125.1:0 800001 0x29391604(-1)
Local LDP ID Local LDP ID of the LDP session to which this upstream mapping CB belongs.
Peer LDP ID Remote LDP ID of the LDP session to which this upstream mapping CB belongs.
Label MPLS label advertised to the upstream LDP LSR.
CB Memory address of the upstream mapping CB.
TABLE 63 Output from the show mpls ldp fec command (Continued)
This field... Displays...