Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 838)

814 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying 6PE information
9
Displaying the 6PE summary
Issue the show ip bgp 6pe summary command to display the 6PE summary. For example, to display
the 6PE summary for the configuration in
Figure 95 , enter the following command.
6PE2# show ip bgp 6pe summary
NLRIs Discarded due to Shows the number of times the router discarded NLRI for the neighbor
due to the following reasons:
•
Maximum Prefix Limit – The configured maximum prefix amount
that had been reached.
•
AS Loop – An AS loop occurred. An AS loop occurs when the BGP4
AS-path attribute contains the local AS number.
•
maxas-limit aspath – The number of route entries discarded
because the AS path exceeded the configured maximum length or
exceeded the internal memory limits.
•
Invalid Nexthop – The next hop value was not acceptable.
•
Invalid Nexthop address - The next hop address was not
acceptable.
•
Invalid Confed aspath - The AS path attribute was not acceptable.
•
Duplicated Originator_ID – The originator ID was the same as the
local router ID.
•
Cluster_ID – The cluster list contained the local cluster ID, or the
local router ID.
Routes Advertised Shows the number of routes that the router has advertised to this
neighbor:
•
To be Sent – The number of routes queued to be sent to this
neighbor.
•
To be Withdrawn – The number of NLRI routes for withdrawing the
routes that the router has queued to send to this neighbor in
Update messages.
NLRIs Sent in Update Message Shows the number of NLRI routes for the new routes that the router has
sent to this neighbor in Update messages:
•
Withdraws – Number of routes the router has sent to the neighbor
to withdraw.
•
Replacements – Number of routes that the router has sent to the
neighbor to replace the existing routes.
Peer Out of Memory Count for Shows the statistics for the count the router has run out of BGP4
memory for the neighbor during the current BGP4 session:
•
Receiving Update Messages – The number of times Update
messages were discarded because there was no memory for
attribute entries.
•
Accepting Routes (NLRI) – The number of NLRI routes discarded
because there was no memory for NLRI routes. This count is not
included in the Receiving Update Messages count.
•
Attributes – The number of times there was no memory for BGP4
attribute entries.
•
Outbound Routes (RIB-out) – The number of times there was no
memory to place a “best” route into the neighbor route information
base (Adj-RIB-Out) for routes to be advertised.
•
Outbound Routes Holder - For debugging purposes only.
TABLE 158 Output parameters of the show ip bgp 6pe neighbors routes-summary
command (Continued)
Field Description