Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 251
Brocade# show mpls statistics tunnel 1
Tunnel In-Port(s) L3VPN/IPoMPLS Out-Pkt
1 e1/1 - e1/20 0
e2/1 - e2/2 0
e3/1 - e3/2 0
e3/3 - e3/4 0
e4/1 - e4/20 0
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
227
53-1003031-02
Displaying MPLS and RSVP information
1
lists the output displayed for the show mpls statistics tunnel command.
TABLE 16
show mpls statistics tunnel parameters
This field...
Displays...
Tunnel
The index number of the MPLS tunnel.
In-Port(s)
The port where the traffic is received.
L3VPN/IPoMPLS Out-Pkt
The number of Layer 3 VPN and IPoMPLS packets that have been sent
outbound meeting the In-label and Tunnel criteria.
Syntax: show mpls statistics tunnel tunnel-index
The tunnel-index variable allows the user to limit MPLS statistics displayed to a specified tunnel.
NOTE
When the traffic is being forwarding using PBR over MPLS tunnel, the MPLS tunnel statistics are not
incremented and only the PBR accounting indicates these packets in the statistics.