Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 247)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 223
53-1003031-02
Displaying MPLS and RSVP information
1
Use the show mpls int command to view the current cached LDP-IGP sync state.
Brocade# show mpls int e2/2
Admin: Up Oper: Up
Maximum BW: 0 kbps, maximum reservable BW: 0 kbps
Admin group: 0x00000000
Reservable BW [priority] kbps:
[0] 0 [1] 0 [2] 0 [3] 0
[4] 0 [5] 0 [6] 0 [7] 0
Last sent reservable BW [priority] kbps:
[0] 0 [1] 0 [2] 0 [3] 0
[4] 0 [5] 0 [6] 0 [7] 0
LDP tunnel count: 0
Current IGP Sync State: Not In Sync
Syntax: show mpls int value
Displaying MPLS and RSVP information
The user can display the following information about the MPLS configuration on the device:
• Information about MPLS-enabled interfaces on the device
• Statistics about the MPLS-enabled interfaces, including bypass LSPs
• MPLS summary information
• Contents of the Traffic Engineering Database (TED)
• Status information about signaled LSPs configured on the device
• Information about paths configured on the device
• The label applied at each hop in an LSP
• Contents of the MPLS routing table
• RSVP information, including the status of RSVP-enabled interfaces, session information, and
statistics
• Information about OSPF-TE LSAs
• MPLS Fast Reroute Information
• MPLS Bypass LSP
Displaying information about MPLS-enabled interfaces
To display information about the interfaces on the device that have been enabled for MPLS, use
the show mpls interface command.