Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 80)

56 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
bandwidth-ceiling max threshold percentage
1
bandwidth-ceiling max threshold percentage
This command sets the threshold for any traffic-rate above the maximum bandwidth-ceiling
configured in the table as a percentage.
The [no] function of this command removes the entry.
Syntax bandwidth-ceiling max threshold percentage threshold percentage
Parameters max
Any rate above the maximum ceiling configured. By default, the last ceiling is used.
threshold percentage
Threshold percentage per second. 0 - 100%. By default, the last ceiling is used.
NOTE
The first parameter indicates that any rate above the maximum ceiling configured, the second
parameter is the threshold in percentage for those rates.
Command
modes
This command operates in MPLS global adjustment threshold configuration mode.
History
Release Command history
Multi-Service NetIron Release 05.6.00 The command was introduced.
Related
commands
None.