Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 632)

608 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
IS-IS shortcuts
5
• How long the LSP has been an IS-IS shortcut
The following shows output from this command.
Brocade# show isis shortcuts lsp tomu2 detail
lsp tomu2
To 10.1.1.1, Used by SPF (10), Not Announced
LSP metric: 10, Relative Metric: -, Announce Metric: -
ISIS System Id for 10.4.1.1 is mu2.00-00
Not announced due to configuration
Last notification from MPLS received 0h0m35s ago.
NOTE
The LSP name in this output is not wrapped.
Syntax: show isis shortcuts detail | lsp lsp-name detail
The optional lsp parameter displays detailed information about IS-IS shortcuts for a specific LSP.
Table 103 defines the fields shown in this output.
TABLE 104 Output for the show isis shortcuts detail command
This field... Displays
name The name of the IS-IS shortcut.
To This line contains the following information:
•
The LSP endpoint address
•
Whether or not this LSP is used in the SPF calculation. This field displays either
Used by SPF or Not Used by SPF
•
Whether or not the announce metric is used.
LSP metric This field displays one of the following:
•
The metric value configured at the MPLS LSP configuration level of the CLI
•
A dash (-), which denotes that the LSP metric is not configured
•
(Ignored) which denotes the Ignore LSP Metric feature is enabled.
Relative metric This field displays one of the following:
•
The relative metric value configured with the shortcuts isis command
•
A dash (-), which denotes that the relative metric is not configured.
Announce metric This field displays one of the following:
•
The announce metric value configured with the shortcuts isis command
•
A dash (-) which denotes that the announce metric is not configured.
IS-IS System Id The matching IS-IS system ID for the LSP endpoint.
Not used by SPF due to When the tunnel is not used by SPF, one of the following reasons is noted:
•
Not used by SPF due to no IS-IS system-id mapping to router-ID. No mapping
exists between the LSP tunnel destination and the IS-IS System ID.
•
Not used by SPF due to no IS-IS native route to LSP tunnel destination. There is
no IS-IS native route to the LSP tunnel destination.
•
Not used by SPF due to IS-IS alternate path preferred to this tunnel. An
alternate path has a better metric than the LSP tunnel.