Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 405)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 381
53-1003031-02
rsvp-hello
2
rsvp-hello
This configures RSVP-TE Hello with default values on all the mpls-interfaces provided the
mpls-interface does not have any local interface level configuration for the same. Interface level
configuration takes precedence over global configuration.
RSVP hello configuration at the global MPLS RSVP level
Interval and tolerance for RSVP-TE Hello protocol can be configured at global MPLS RSVP level. The
global configuration is pushed to all the mpls-interfaces if interface level configurations is not
present. In addition to these two parameters, one more parameter can be configured at global
MPLS RSVP level, namely, acknowledgements.
TABLE 45 RSVP hello configuration at the global MPLS RSVP level
Configuration
command Default value Vaild range Comments
rsvp-hello This will enable the RSVP-TE Hello feature with
default values on all the mpls-interfaces if no
interface level configuration is present for RSVP
Hello.
interval value 9 seconds 1 -60 seconds
tolerance value 3 1 -255
The [no] form of the command does not take interval or tolerance as parameters. So, on executing
no rsvp-hello command on the global MPLS RSVP level removes the global configuration for hello.
All the mpls-interfaces which does not have an interface level configuration for RSVP-TE Hello will
now stop executing (disable) hello protocol on that interface.
Hello-interval and hello-tolerance at mpls-interface level
RSVP-TE Hello interval and tolerance can be configured at mpls-interface level as well. Interface
level configurations take precedence over global configurations. These parameters can be
individually configured for each mpls-interface.
TABLE 46
Configuration
command Default value Vaild range Comments
rsvp-hello This will enable the RSVP-TE Hello feature with
default values as below.
interval value 9 seconds 1 -60 seconds
tolerance value 3 1 -255
Hello-interval and hello-tolerance at mpls-interface level
The [no] form of the command does not take interval or tolerance as parameters. Executing no
rsvp-hello command on the mpls-interface level would set the RSVP-TE Hello parameters to the
globally configured RSVP Hello parameter values. If RSVP Hello is not configured globally, then it
would disable RSVP Hello on the mpls-interface. Executing this would remove the configuration
from the interface level and would no longer display RSVP Hello configuration at the interface level
in the show configuration.
Syntax rsvp-hello [acknowledgements|interval value |tolerance value]