GW Instek GBS-1000 Series User Manual - Manual (Page 170)

GBS-1000 Series User Manual
170
USB/RS-232C remote control software
Terminal
application
(USB/RS-232C) Invoke the terminal application such as MTTTY
(Multi-Threaded TTY). For RS-232C, set the COM
port, baud rate, stop bit, data bit, and parity
accordingly.
To check the COM port No, see the Device
Manager in the PC. For WinXP, Control panel →
System → Hardware tab.
Functionality
check Run this query command via the terminal.
*idn?
This should return the Manufacturer, Model
number, Serial number, and Firmware version in
the following format.
GW, GBS-1074, 000000001, V1.00
PC Software
(USB only) The proprietary PC software, downloadable from
GWInstek website, can be used for remote control.
This mode is available only for the USB interface.