GW Instek GBS-1000 Series User Manual - Manual (Page 179)

APPENDIX
179
Trigger Sources CH1, CH2, CH3, CH4, Line
Modes Auto-Level, Auto, Normal, Single, TV,
Edge, Pulse Width
Coupling AC, DC, LFrej, HFrej, Noise rej
Sensitivity DC~25MHz: Approx. 0.5div or 5mV
25MHz~max: Approx. 1div or 10mV
Horizontal Range 1ns/div~10s/div, 1-2-5 increment
Roll mode: 250ms/div ~ 10s/div
Modes Main, Window, Window Zoom, Roll, Scan,
X-Y
Accuracy ±0.01%
Pre-Trigger 20 div maximum
Post-Trigger 1000 div
X-Y Mode X-Axis Input Channel 1
Y-Axis Input Channel 2, 3, 4
Phase Shift ±3° at 100kHz
Signal Acquisition Real-Time 1G Sa/s maximum
Equivalent 25G Sa/s maximum
Vertical
Resolution 8 bits
Record Length 25K Dots Maximum
Acquisition Normal, Peak Detect, Average
Peak Detection 10ns
Average 2, 4, 8, 16, 32, 64, 128, 256
Cursors and
Measurement Voltage Vpp, Vamp, Vavg, Vrms, Vhi, Vlo, Vmax,
Vmin, Rise Preshoot/ Overshoot, Fall
Preshoot/ Overshoot
Time Freq, Period, Rise Time, Fall Time, Positive
Width, Negative Width, Duty Cycle
Delay FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF
Cursors Voltage difference (ΔV) and
Time difference (ΔT) between cursors
Auto Counter Resolution: 6 digits
Accuracy: ±2%
Signal source: All available trigger source
except the Video trigger
Control Panel
Function Auto Set Automatically adjust Vertical Volt/div,
Horizontal Time/div, and Trigger level
Save Setup Internal memory: 20 sets
USB Flash drive: unlimited
Save Waveform Internal memory: 20 sets
USB Flash drive: unlimited
Save display
image USB Flash drive: unlimited