GW Instek GBS-1000 Series User Manual - Manual (Page 174)

GBS-1000 Series User Manual
174
F
AQ
• I pressed the Power (On/Standby) key on the front panel but nothing
happens.
• I connected the signal but it does not appear on the display.
• I want to remove the (Measurement result / FFT result / Help
contents) from the display.
• The waveform does not update (frozen).
• The probe waveform is distorted.
• Auto Set does not catch the signal well.
• I want to clean up the cluttered panel settings.
• The display image printout is too dark on the background.
• The date and time settings are not correct.
• USB does not work.
• The accuracy does not match the specification.
I pressed the Power (On/Standby) key on the front panel
but nothing happens.
Make sure you turned On the rear panel Power switch. For the
power up sequence, see page23.
I connected the signal but it does not appear on the display.
Make sure you have activated the channel by pressing the Channel
key (the LED turns On).