GW Instek GBS-1000 Series User Manual - Manual (Page 18)

GBS-1000 Series User Manual
18
Rear Panel

 





 


Power
socket
Fuse
socket
RS232C
port
USB Slave
Connector
Power
switch
Calibration Output
Terminal
GO-NoGO Output
Terminal
USB Host
Connector
Power switch
Power cord
socket
Fuse socket
Power switch turns the main power
On ( ) / Off (
).
Power cord socket accepts AC
mains, 100 ~ 240V, 50/60Hz.
Fuse socket holds AC main fuse,
T2A/250V.
For power up sequence, see page23.
For fuse replacement procedure, see
page177.
RS232C port Accepts DB-9 RS-232C connector
for remote control (page168).
USB slave port Accepts typeB connector for remote
control (page167) or PC software
connection. USB 1.1/2.0 full speed
compatible.