HP NonStop G-Series - Manual (Page 112)

There are two FC-AL I/O modules in each FCDM. These modules are the interface between the
FCDM elements and the host controller. They route data to and from the drives using loop A and
loop B.
Location in OSM Tree: System > Group > FCDM Collection > FCDM > FC-AL I/O Module
Example: FC-AL I/O Module (111.211.1.93)
Attributes
FC-AL I/O Module
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Physical
LED State
Indicates whether or not the FC-AL I/O Modules (amber) fault LED is blinking.
Value: Blinking or Off
Type The vendor hardware type.
Logical
Device State
The state of the component as known to the operating system on the
server.
Values
Vendor Hardware Revision
A code that identifies the generation of the component provided by its
supplier.
Device Connection
Configured
Controller Location
The location of the configured FCSA connected to the FC-AL I/O Module.
Example: FCSA.FSAC-1.GRP-111.MOD-2.SLOT-1
Fibre Channel
Controller
The number that identifies the FCSA FSAC connected to the FC-AL I/O
Module.
Example: FCSA FSAC (111.2.1.1)
Actions
Blink LED Off
Turns off the blinking of the FC-AL I/O Modules (amber) fault LED.
SCF Equivalent: SCF Control SAC $ZZSTO.#sac-name, deviceid(shelf,bay), LED OFF
Blink LED On