HP NonStop G-Series - Manual (Page 261)

Connectivity Status
The status of the port.
Values:
Port reset
Loss of optical signal
Transceiver absent
PIC absent
No link alive
Link Alive - Port disabled
Neighbor check in progress
Neighbor check complete - Port disabled
Neighbor check failed - No link alive
Connected to switch
Connected to switch with wrong numeric selector
Connected to switch with invalid configuration version identifier
Connected to wrong port
Connected to different switch
Connected to switch with incompatible configuration
No response to Manage Port command from neighbor port
Manage Port command not acknowledged (NACKed) from
neighbor port
Port enabled
Invalid
Unknown
Current Speed The speed of the port in bits per second.
Transceiver Device State
The initial state of the component at the time of discovery.
Values: OK, Fault
Transceiver Enabled State
Whether the transceiver is enabled.
Enabled: The component is operational.
Disabled: The component is present but not operational.
Fabric State
The state of the external ServerNet fabric from the local node to the
remote node connected via this port.
Up: At least one of the processors on the local node can
communicate with at least one processor on one of the remote
nodes.
Down: No processor on the local node can communicate with any
processor on any remote node.
Neighbor ServerNet Node