HP NonStop G-Series - Manual (Page 122)

Note: The ports on a Fibre Channel ServerNet adapter are numbered from top down when you
view the FCSA installed in a rack. Thus, FCSA FSAC 1 is attached to the upper port (port
1), FCSA FSAC 2 is attached to the lower port (port 2).
Attributes
FCSA FSAC
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Node Name
A number (read from the hardware) that uniquely identifies each FCSA FSAC. Until
an attached disk is configured and started, the Node Name attribute is displayed as
0xFFFFFFFFFFFFFFF.
Port Name
A number (read from the hardware) that uniquely identifies each Fibre Channel port
connected to the FCSA FSAC. Until an attached disk is configured and started, the
Port Name attribute is displayed as 0xFFFFFFFFFFFFFFF.
Actions
Responsive Test
Verifies that the FCSA FSAC is present and responding. (To pass the test, a disk using this FSAC
must be configured and started.)
FESA (Fast Ethernet ServerNet Adapter)
Attributes
Actions
An adapter that connects the ServerNet connections inside a server to a 10/100Base-TX local area
network (LAN).
The Fast Ethernet ServerNet adapter (FESA) CRU contains one Fast Ethernet ServerNet addressable
controller (
SAC ), which contains one Ethernet physical interface, that corresponds to the one
Ethernet port on each FESA CRU.
Location in OSM Tree: System > Group > Module > FESA
Slot Location: FESA CRUs can be located in slots 53 and 54 in processor enclosures (service side)
or in slots 51, 52, 53, and 54 in IOMF or IOMF2 enclosures (service side).
Example: FESA $ZZLAN.FESA1 (1.1.53)