HP NonStop G-Series - Manual (Page 62)

Performing Firmware Updates
Performing a Firmware Update
To update down-rev firmware for a specific resource, use one of the actions available for that
resource.
Performing a Firmware Update
Select Display>Multi-Resource Actions. 1.
From the Resource Type drop-down list, select the type of resource on which to perform
the firmware update. All resources of the selected type appear in the available resources
list. 2.
From the Action drop-down menu, select the action to perform. A second resources list is
displayed below the first:
You can resize the panes by using the divider line above the add and remove
buttons. ●
You can sort either resources list by clicking the bottom line of the column
heading. ●
3.
To further refine the resources on which to perform the firmware update, select a
parameter from the Filter by drop-down list. Only resources in the available resources list
with the specified characteristic are displayed.
Some actions, such as SP Firmware Updates should not be performed on all SPs
simultaneously. For these potentially disruptive actions, the Filter by menu forces you to
choose between X-fabric or Y-fabric SPs.
The Compare State - Down-rev parameter is shown only if any down-rev firmware
actually exists.
4.
Select the specific resources on which to perform the action:
Select To
Add all
Move all resources in the available resources list to the selected resources
list. (The Add all button is enabled only when no resource in the available
resource list is highlighted.)
Add
Move a specific resource (selected by clicking it) from the available list to
the selected list.
Remove all Move all resources from the selected list back to the available list.
Remove
Move a specific resource (selected by clicking it) from the selected list back
to the available list.
5.