HP NonStop G-Series - Manual (Page 128)

Start
Starts the ServerNet/FX or ServerNet/FX 2 adapter field-replaceable unit (FRU) that is in the
Stopped state. During startup, the controller operational code is automatically loaded into the FRU.
When the Start action completes, the FRU is in the Started state.
Stop
Stops the ServerNet/FX or ServerNet/FX 2 adapter field-replaceable unit (FRU) that is in the Started
state. When the Stop action completes, the FRU is in the Stopped state.
Test Verify
Runs all the firmware diagnostic tests on the ServerNet/FX or ServerNet/FX 2 adapter
field-replaceable unit (FRU). This test takes about 10 minutes to complete. You must use the Stop
action to place the FRU in the Stopped state before you initiate the Test Verify action.
G4SA
Attributes
Actions
The M8800 Gigabit Ethernet 4-port ServerNet adapter (G4SA) provides Gigabit connectivity
between NonStop servers and Ethernet LANs. G4SAs are installed in slots 1 through 5 of an
I/O
Adapter Module (IOAM).
Each G4SA contains one G4SA SAC , which contains up to four G4SA PIF s, resulting in four
Ethernet ports on each G4SA. For more information about the G4SA, including diagrams to identify
specific ports, see the Gigabit Ethernet 4-Port Adapter Installation and Support Guide.
Note: If a ServerNet switch board is not present, G4SAs will not appear in OSM.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > G4SA
Example: G4SA $ZZLAN.G4SA1 (13.3.2)
Attributes
G4SA
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Physical
Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.