HP NonStop G-Series - Manual (Page 179)

Attributes
SAC
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Values
Physical
The Physical attributes are displayed only when the SAC is a subcomponent of a CCSA.
Device ID
The ID assigned by the device manufacturer.
Example: 0x860
Part Number
The Part Number of the component that was assigned in manufacturing. Use part
numbers for identifying and ordering parts.
SAC Type Identifies the type of SAC.
Vendor ID
The manufacturer of the device.
Example: 0x10E3
Logical
Dump Filename The name of the file used to store dumps of the SAC memory.
Automatic Boot State
Indicates whether the SAC boot firmware is automatically reloaded if it
terminates abnormally:
Enabled: The boot firmware is automatically reloaded.
Disabled: The boot firmware is not automatically reloaded.
Unknown: Automatic Boot state could not be read.
Automatic Dump State
Whether the SAC software is automatically dumped to the specified dump
file if the software abends abnormally:
Enabled: The software is automatically copied to a dump file.
Disabled: The software is not automatically copied to a dump file.
Unknown: Automatic Dump state could not be read.
Processor Access List
The currently available processors that can access the SAC.
Example: 0,1
Device State
The state of the component as known to the operating system on the server.
Values
Owning Processor
The processor to which the SAC is connected.
Example: 0
Download File Name The file name of the operational firmware running on the SAC.