Disk, Attributes – HP NonStop G-Series User Manual
Page 86
if the CCSA is currently in use (and stops it only after you confirm).
Test Verify
Checks the health of the Common Communication ServerNet adapter (CCSA) CRU. It determines
whether the CCSA CRU can communicate with at least one SAC on the board.
Disk
An internal 3.5-inch hard disk drive. Each disk drive connects to one of two SCSI buses on either a
(
),
Disk CRUs can be located in slots 01 through 08 and slots 11 through 18 in processor and I/O
enclosures (appearance side). SCSI terminators are in slots 09, 10, 19 and 20, for a total of 16
available disk slots.
Location in OSM Tree: System > Group > Module > Disk
Example: Disk $SYSTEM-P (1.1.11)
Attributes
Disk
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Physical
Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.
Manufacturer
Identifies the manufacturer of the component.
Part Number
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts.
Power State
Indication of whether the component is powered on.
Track ID
A unique serial number that identifies the component. Track IDs are used for
tracking components.
Logical
Active Path
The path that is currently accessing the disk.
Values: Primary, Backup, Mirror, Mirror Backup