Actions – HP NonStop G-Series User Manual
Page 118
Information about the version of the operational firmware located in the Flash memory of the FCSA.
This firmware is not used in NonStop S-series systems, as system load through an FCSA is not
supported on S-series.
Version
The version of the flash firmware running on the FCSA.
Default File Name
The name of the file to be used for a firmware update.
Default File Version The version of the firmware to be used for a firmware update.
Compare State
Indication of the differences, if any, between the current and default firmware
versions.
Flash Boot Firmware
Information about the version of the boot firmware located in the Flash memory of the FCSA.
Version
The version of the boot firmware running on the FCSA.
Default File Name
The name of the file to be used for a firmware update.
Default File Version The version of the firmware to be used for a firmware update .
Compare State
Indication of the differences, if any, between the current and default firmware
versions.
Actions
Flash Boot Firmware Update
Updates the boot firmware in Flash memory of the FCSA. It is not possible to do this update unless
the FCSA has a disk configured through it. If the Flash Boot Firmware Compare State is Unknown,
an update attempt will likely fail.
Flash Firmware Update
Updates the operational firmware in Flash memory of the FCSA.
Note: This firmware is not used on NonStop S-series systems, as system load through an FCSA
is not supported on S-series.
Replace
Launches an interactive action to assist with replacement of an FCSA.
Note: This replacement procedure is intended for authorized service providers only.
When initiated, OSM checks for any connected paths that do not have a backup and warns you of
any connectivity loss that could result from continuing with the action. OSM also directs you to the
online help for precautionary guidelines for handling the hardware. See: