Actions, Group (ioam), Attributes – HP NonStop G-Series User Manual
Page 136
Actions
Power Off
Upon initiating the action, it first performs precautionary checks to ensure that you can safely power
off. These checks ensure that:
If the group is an enclosure on the inner tetrahedral ring, there are no enclosures off this
enclosure.
●
There are no IOMF enclosures off this enclosure.
●
If the checks complete successfully, or you choose to disregard any warnings and proceed, the action
allows you to disable the batteries and halt the processors.
After these operations complete successfully (or you choose to disregard any warnings), you can
complete the action and power off the group.
Set Service LED State
Turns the service light-emitting diode (LED) on or off for this group. Use this action to mark an
enclosure to make it easily locatable for service.
Parameter: Service LED State
on: turns LED on
off: turns LED off
Group (IOAM)
An IOAM Group contains an
and
contain Fibre Channel disk modules (FCDMs) that are connected to this IOAM enclosure. If an
FCDM is connected to FCSAs located in different IOAM enclosures (for increased fault tolerance),
OSM displays the FCDM Collection in the lower-numbered group.
Numbering of IOAM groups starts at 11.
Attributes
Group
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.