HP NonStop G-Series - Manual (Page 209)

Part Number
The part number of the component that was assigned in manufacturing. Use part
numbers for identifying and ordering parts. This is not the spare part number.
Serial Number The serial number of the tape drive (where applicable).
Process Pair
Configured Processors
The two processors in which this I/O process is configured to run.
Example: 0,1
Primary Execution State
The state of the primary I/O process.
Values: Running, Stopped
Primary Process ID
The process ID of the primary I/O process. If the state of the primary I/O
process is Stopped, this ID is not displayed.
Example: 1,296
Backup Execution State
The state of the backup I/O process.
Values: Running, Stopped
Backup Process ID
The process ID of the backup I/O process. If the state of the backup I/O
process is Stopped, this ID is not displayed.
Example: 1,285
Controller Path
SCSI ID An identification number assigned to the device when configured.
SCSI Controller
The number (3) that identifies the SCSI controller that manages the tape
drive.
Example: SSAC (1.1.55.3)
Configured
Controller Location
The location of the SCSI controller.
Example: IOMF2.SAC-3.GRP-1.MOD-1.SLOT-55
Actions
Responsive Test
Verifies that the component is installed and responding.
Start
Puts the tape process in a state to accept regular I/O commands to the tape drive. When the Start
action completes, the drive is in the Started state.
Note that Start is a logical command and does not affect the hardware.
Stop