Attributes, Actions – HP NonStop G-Series User Manual
Page 136
Each node in a ServerNet cluster must have two MSEBs for fault tolerance, one for connectivity to a
switch on the X fabric and the other for connectivity to a switch on the Y fabric.
Location in OSM Tree: System > Group > Module > MSEB
Slot Location: MSEBs must be located in slots 51 and 52 of processor enclosures (service side).
Example: MSEB (1.1.51)
Attributes
MSEB
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required.
Physical
Power State
Whether the component is powered on.
Part Number
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts.
Track ID
A unique serial number that identifies the component. Track IDs are used for
tracking components.
Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.
Logical
Disabled ServerNet Ports
Which, if any, ServerNet router ports on this CRU are disabled. OSM
actions to disable or enable a ServerNet port are performed as directed by
OSM alarm repair actions.
Actions
Disable ServerNet Port
Disables the specified ServerNet port on this CRU. Perform this action only as directed by OSM
alarm repair actions.
Parameter: Port Number
Enable ServerNet Port
Enables the specified ServerNet port on this CRU. Perform this action only as directed by OSM
alarm repair actions.
Parameter: Port Number