HP NonStop G-Series - Manual (Page 185)

Attributes
Tape Drive
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required.
Values
Logical
Ready Status
The availability of the tape:
Ready: Tape is loaded.
Not Ready: No tape is loaded.
Unknown: Tape status cannot be determined.
Logical Device Number The number assigned to the drive by the file system.
Tape Type The type of tape drive. Values .
Product ID The tape drive product identification.
Device State
The accessibility of the tape drive through the tape process.
Values: Up, Down, Hard Down
Firmware version The version of the firmware.
Physical
Part Number
The part number of the component that was assigned in manufacturing. Use part
numbers for identifying and ordering parts. This is not the spare part number.
Serial Number The serial number of the tape drive.
Process Pair
Configured Processors
The 2 processors in which this I/O process is configured to run.
Example: 0,1
Primary Execution State
The state of the primary I/O process.
Values: Running, Stopped
Primary Process ID
The process ID of the primary I/O process. If the state of the primary I/O
process is Stopped, this will not be displayed.
Example: 1,296
Backup Execution State
The state of the backup I/O process.
Values: Running, Stopped