HP NonStop G-Series - Manual (Page 54)

To further refine the resources on which to perform the firmware update, select a
parameter from the Filter by drop-down list. Only resources in the available resources list
with the specified characteristic are displayed.
Some actions, such as SP Firmware Updates should not be performed on all SPs
simultaneously. For these potentially disruptive actions, the Filter by menu forces you to
choose between X-fabric or Y-fabric SPs.
The Compare State - Down-rev parameter is shown only if any down-rev firmware
actually exists.
4.
Select the specific resources on which to perform the action:
Select To
Add all
Move all resources in the available resources list to the selected resources
list. (The Add all button is enabled only when no resource in the available
resource list is highlighted.)
Add
Move a specific resource (selected by clicking it) from the available list to
the selected list.
Remove all Move all resources from the selected list back to the available list.
Remove
Move a specific resource (selected by clicking it) from the selected list back
to the available list.
5.
Click Perform Action.
As the firmware update is performed, its status appears to the left of the resource name in
the selected resources list.
A summary of the action progress is shown in the Progress status boxes.
6.
To view a summary of the actions, click Action Summary. (For information on action
details, see
Viewing Action Details .)
7.
Launching Guided Procedures
These guided procedures are available:
Guided Procedure Launched by Action On Resource
Add Node to ServerNet Cluster Add Node to ServerNet Cluster System
Replace PMF Replace
PMF
PMF2
Replace IOAM Enclosure or
ServerNet Switch Board
Replace IOAM Enclosure or
ServerNet Switch Board
IOAM Enclosure
Replace ServerNet Switch Board