HP NonStop G-Series - Manual (Page 156)

Default File Version
The version of the firmware to be used for the Boot Millicode firmware
update.
Compare State
The differences, if any, between the running and default firmware versions.
Values
Actions
Disable Processor Freeze
Turns off the Freeze Enable flag on this processor. A freeze-disabled processor both:
Participates in a system freeze only when the processor itself halts ●
Is unaffected when any other processor halts or the system Freeze action is performed ●
Halt
Terminates all processes running on this processor. Halting a processor does not affect any other
processors in the system.
Caution: Halting a processor might result in unrecoverable loss of data. Use the Halt action only
to prepare for reloading the processor or for performing a memory dump.
Online Boot Millicode Firmware Update
Updates the Boot Millicode firmware running on the processor.
Online Boot Millicode Firmware Update is not supported for processors in S7000 PMF CRUs or on
systems running G06.11 or older. The related attributes and action will not be displayed for
processors on which this action is not supported.
Optional Parameter: File Name
Reload
Loads the operating system into the processor from a specific disk location.
Reset
Stops the processor and terminates all processes running on it. Places the processor in a known state,
ready for a Prime for Reload action or Load action.
Responsive Test
Verifies that the processor is configured and responding.