HP NonStop G-Series - Manual (Page 98)

Updates disk drive firmware.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary if the disk was
in a STOPPED state, substate HARDDOWN; a hardware error has occurred; the disk was stopped
with an ABORT command; or a STOP or ABORT fails to put the disk into the STOPPED state,
substate DOWN.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Start Backup Path
Starts the backup path to this disk drive. When the Start action completes, the backup path is in the
started State.
Start Disk
Starts all paths to this disk drive. When the Start action completes, the all paths are in the Started
state.
Start Primary Path
Starts the primary path to this disk drive. When the Start action completes, the primary path is in the
Started state.
Start Volume
Starts all paths for both the primary and mirror drives of this volume.
Stop Backup Path
Terminates operation of the backup path to the disk. When the Stop action finishes, the path is in a
Down state. If the disk drive is currently in use, a dialog box warns you and asks whether or not you
want to continue with the action.