HP NonStop G-Series - Manual (Page 221)

Set Fabric Setting
Sets the fabric LED indicator for the ServerNet II Switch to either X or Y.
Within three minutes after the action completes, the SANMAN process running on each of the
nodes discovers that the fabric setting has been corrected and accepts the new switch.
Parameter: Fabric Setting can be set to Unknown, Clear, X,or Y.
SCF Equivalent: SCF ALTER SWITCH $ZZSMN, NEAREST { X | Y }, FABRIC { X| Y }
Soft Reset
Used following a Firmware Update action on the switch for the changes to take effect.
SCF Equivalent: SCF RESET SWITCH $ZZSMN, NEAREST { X | Y }, SOFT
Switch Fan
A component that circulates air into the enclosure to help maintain optimal temperature.
Location in OSM tree: External ServerNet Fabric > Switch Group > Switch Module > Switch
Fan
Example: Fan (1020.1.16)
Attributes
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or
service is required.
Values
Physical
Presence
Whether the fan is installed and responding.
Values: Present, Absent, Unknown
LED State
The state of the fault LED on the fan.
Values: On, Off, Flash
Logical