HP NonStop G-Series - Manual (Page 170)

Configured Processors
The 2 processors in which this I/O process is configured to run.
Example: 0,1
Primary Execution State
The state of the primary I/O process.
Values: Running, Stopped
Primary Process ID
The process ID of the primary I/O process. If the state of the primary I/O
process is Stopped, this will not be displayed.
Example: 1,296
Backup Execution State
The state of the backup I/O process.
Values: Running, Stopped
Backup Process ID
The process ID of the backup I/O process. If the state of the backup I/O
process is Stopped, this will not be displayed.
Example: 1,285
SCSI Interface
SCSI ID
An identification number assigned to the device when configured.
8: SCSI-to-Fiber extender / SCSI to Fiber Converter
9: Fiber-to-SCSI extender
SCSI Controller
The number that identifies the SCSI controller that manages the storage router.
If this attribute is missing, it is because the SCSI Controller has been removed
from the system.
Example: SSAC (1.1.50.3)
Actions
Responsive Test
Verifies that the resource is configured and responding.
Switch Process Pair
Switches processors of the primary and backup tape I/O processes
SWAN / SWAN2 CRU
The ServerNet wide area network (SWAN) concentrator CRU is an external communications device
that connects to a system through dual Ethernet ports. It supports both synchronous and
asynchronous protocols over a variety of electrical interfaces. The SWAN CRU object displayed by
OSM can be either a SWAN or SWAN 2 CRU. To distinguish between them, look at their