HP NonStop G-Series - Manual (Page 153)

Power Supply (IOAM)
Supplies power to the IOAM . There are two IOAM power supply units in each IOAM.
For information on how to replace an individual Power Supply, see the see the CSSI web site .
Note: If a ServerNet switch board is not present, the IOAM power supplies will not appear in
OSM.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > Power Supply
Example: Power Supply (13.2.15)
Attributes
IOAM Power Supply
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required.
Values
Physical
Part Number
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts.
Vendor Model Number
The model number of the component assigned to it by the supplier of the
component.
Vendor Revision
A code that identifies the generation of the component. Assigned by the
supplier of the component.
Vendor Part Number
The part number of the component assigned to it by the supplier of the
component.
Vendor Serial Number
The serial number of the component assigned to it by the supplier of the
component.
Logical
Device State The state of the component as known to the operating system on the server. Values
Processor
A processor or central processing unit (CPU).
In S-series servers, a Processor is a component of the processor multifunction ( PMF )
customer-replaceable unit (CRU). Each processor enclosure in a NonStop S-series server contains
two PMF CRUs and therefore two processors.
Location in OSM Tree: System > Group > Module > PMF2 > Processor