HP NonStop G-Series - Manual (Page 189)

Attributes
Unknown CRU
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required.
Values
Physical
Power State Whether the component is powered on. Values
Actions
None.
UPS (IOAM)
The uninterruptible power supply (UPS) unit for the IOAM enclosure.
Location in OSM Tree: System > Monitored Service LAN Devices > UPS
Example: UPS SDUPS
Attributes
UPS (IOAM)
Battery Status
Indicates the current status of the UPS battery. Possible values are
Normal and On Battery.
OSM displays a yellow alarm if the UPS goes On Battery (or starts
drawing power from the battery). This alarm goes away when the UPS
stops drawing power from the battery. OSM displays a red alarm when
the battery power is low.
Device Status Indicates whether the UPS is up or down.
Identificaton Information
Displays additional information about the UPS as set by super-user in the
web interface (see the
Link to Web Interface action). Up to 20 characters
are allowed.
Example: UPS Web Card
IP Address The IP address of the UPS.
VA Rating
This is the apparent power rating of the UPS, expressed in Volt-Amperes.
Example: 12000 VA
UPS Location
Displays the physical location of the UPS as set by super-user in the the
Link to Web Interface action.