Attributes, Actions, Swan line – HP NonStop G-Series User Manual
Page 177: Wan lines, Giving each swan cru as many as six wan ports, And two
Attributes
LAN LB $ZZWAN
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required.
Physical
Part Number
The part number of the component that was assigned in manufacturing. Use
part numbers for identifying and ordering parts.
Track ID
A unique serial number that identifies the component. Track IDs are used for
tracking components.
Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.
Logical
Link State
The status of the Ethernet link.
Values: Up, Down, Not Available
Duplex Mode
The duplex mode of the connection between the logic board and the router.
Values: Half Duplex, Full Duplex, Not Available
Maximum Speed
The maximum speed of the connection between the logic board and the router.
Values: 10Mbps, 100Mbps, Not Available
Board State
The operational status of the SWAN 2 LAN logic board CRU.
Values: OK, Fault, Not Available
Actions
None.
SWAN Line
s and SWAN 2 CLIPs. Every CLIP has two lines, which represent
the ports on the CLIP.
Location in OSM Tree: System > SWAN Collection > SWAN > CLIP > Line
Example: Line $ZZWAN.#SWAN2.1.0