Apple Final Cut Pro 5 - Manual (Page 1549)

198 Part III Output
4 If you haven’t already done so, set In and Out points for your clip or sequence in the
Viewer, if you don’t want to output the entire clip or sequence.
5 In the Edit to Tape window, cue the tape where you want to start your initial edit, then
press I, click the Mark In button, or type a value and press Return.
Note: You do not need to set an Out point for an assemble edit.
6 If you are including leader elements using Mastering mode, click the Mastering
Settings tab, then select the elements you want to include before and after your
sequence or clip.
For an explanation of the leader and trailer options, see “ Adding Standard Leader and
Trailer Elements ” on page 195.
7 To perform the assemble edit, do one of the following:
 Drag your clip or sequence from the Viewer or Browser to the Assemble section of
the Edit Overlay.
 Open your clip or sequence in the Viewer, then click the Assemble Edit button.
 Drag the clip or sequence to the Assemble Edit button.
If desired, set In and Out points
for the part you want to record.
Drag the clip or
sequence here to do
an assemble edit.
Or click the Assemble
Edit button.