Apple Final Cut Pro 5 - Manual (Page 1551)

200 Part III Output
To perform an insert edit:
1 Choose File > Edit to Tape.
In most layouts, the Edit to Tape window appears on top of the Canvas.
2 Choose Editing or Mastering mode from the pop-up menu in the top center of the
window.
For more information about the Editing and Mastering modes, see “ Video Tab ” on
page 189.
3 Select a clip or sequence in the Browser.
4 If you haven’t already done so, set In and Out points for your clip or sequence in the
Viewer, if you don’t want to output the entire clip or sequence.
Use three-point editing to set your In and Out points. For more information on three-
point editing, see Volume II, Chapter 10, “Three-Point Editing.”
The preview option is
disabled if you are using
DV equipment.
Set In and Out points for the
part you want to record.
Choose a mode from
this pop-up menu.