INFICON STM-2XM 2-Channel Rate/Thickness Monitor - Manual (Page 111)

5 - 31
PN
07
4-
61
4-
P1
A
STM-2XM Operating Manual
5.8.9 Command: O
Command Type . . . . . . . . . . . . . . . . Remote
Command Structure . . . . . . . . . . . . . CEVNTID_class Eid EVENT GROUP
command
Syntax. . . . . . . . . . . . . . . . . . . . . . . . On
Description . . . . . . . . . . . . . . . . . . . . Zeroes thickness, opens or closes a shutter,
selects a sensor if in backup mode, and
forces a final thickness. This command
corresponds with the remote actions using
the front panel buttons, where n is 1 to 13.
Parameters. . . . . . . . . . . . . . . . . . . . (See Table 5-5 .)
Table 5-5 O command
# Command Structure Description
1 CEVNTID_AckMemLoss Ack memory loss state if present
2 CEVNTID_RCzeroch1 Zero Channel 1 thickness
3 CEVNTID_RCzeroch2 Zero Channel 2 thickness
4 CEVNTID_RCGoOpen1 Open Channel 1 shutter function
5 CEVNTID_RCGoOpen2 Open Channel 2 shutter function
6 CEVNTID_RCGoClosed1 Close Channel 1 shutter function
7 CEVNTID_RCGoClosed2 Close Channel 2 shutter function
8 CEVNTID_RCSelectXtl1 Select Sensor 1 in backup mode
9 CEVNTID_RCSelectXtl2 Select Sensor 2 in backup mode
10 CENVTID_RCFnlThkTrgr1 Force final thickness event Channel 1
11 CENVTID_RCFnlThkTrgr2 Force final thickness event Channel 2
12 CENVTID_RCFnlThkTrgrDual Force final thickness in both channels
13 CEVNTID_RCGoAlloy Allow sync, channel non-specific
(Alloy mode)
14 CEVNTID_UIFEvnt User interface event
Reset User Display
Dim down timeout
Illuminate display as though a button was
pressed or the spin knob was rotated