INFICON STM-2XM 2-Channel Rate/Thickness Monitor - Manual (Page 113)

5 - 33
PN
07
4-
61
4-
P1
A
STM-2XM Operating Manual
5.8.10.1 Alloy State Class
AlloyState_BOGU. . . . . . . . . . . . . . . 0
Unset, invalid value at startup
AlloyState_INACTIVE. . . . . . . . . . . . 1
Not alloying system mode, not a possibility
AlloyState_XTALBADA . . . . . . . . . . . 2
Non-depositing, only Channel 1 crystal bad
AlloyState_XTALMNLA . . . . . . . . . . 3
Non-depositing, Channel 1 crystal was bad,
a manual override on Channel 1 only
AlloyState_XTALBADB . . . . . . . . . . 4
Non-depositing, only Channel 2 crystal bad
AlloyState_XTALMNLB. . . . . . . . . . . 5
Non-depositing, Channel 2 crystal was bad,
a manual override on Channel 2 only
AlloyState_XTALBAD2 . . . . . . . . . . . 6
Non-depositing, both Channel 1 and 2 crystal
bad
AlloyState_XTALMNL2 . . . . . . . . . . . 7
Non-depositing, both Channel 1 and 2
crystals were bad, manual overrides on both
NOTE: Above have/had a bad crystal and/or did a manual override, processing
cannot start up until goes to idle.
AlloyState_IDLE . . . . . . . . . . . . . . . . 8
Non-depositing no manual overrides, both
crystals good at present
AlloyState_SDA . . . . . . . . . . . . . . . . 9
Shutter delay A, Channel 1 started and
waiting on 2
AlloyState_SDB . . . . . . . . . . . . . . . . 10
Shutter delay B, Channel 2 started and
waiting on 1
AlloyState_SD2 . . . . . . . . . . . . . . . . 11
Both channels in shutter delay, waiting for
synchronous exit
AlloyState_CODEP. . . . . . . . . . . . . . 12
Both channels actively engaged in a
codeposition until end thickness, manual
shutdowns, crystal fails, or Coast to Time
Power