Lenze E84AYCEO - Manual (Page 100)

12 Error messages
12.2 Possible causes and remedies
100
Lenze · E84AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 10/2013 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
EtherNet/IP: Idle Mode [0x01bc8132]
EtherNet/IP: Duplicate IP Address [0x01bc8273]
Response (Lenze setting printed in bold) Setting: C13880/1
 None  system fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
• Scanner has received an idle event.
• The scanner is in the "PROG" mode.
• In the "Scanner Command Register", the run/
idle flag (bit 0) is 0.
Set the scanner to the run mode.
Run/idle flag (bit 0) = 1
Response (Lenze setting printed in bold) Setting: not possible
 None  system fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An IP address has been allocated twice within the
network. The addresses of the network nodes must differ
from each other.
Correct the IP address ( C13000 ).
 Setting the IP configuration of the Inverter Drive 8400
( 42)