Lenze E84AYCEO - Manual (Page 44)

6 Commissioning
6.4 Setting the IP configuration of the Inverter Drive 8400
44
Lenze · E84AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 10/2013 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. A double-click on a EtherNet/IP node opens the "Configure nodes" dialog window.
Here you can set the IP parameters.
3. Click on Transferred.
• The IP configuration is transferred to the corresponding EtherNet/IP node.
• The communication module carries out a stack reset.
• The IP parameters are written to codes
C13000 (IP address), C13001 (subnet mask), and
C13002 (gateway address).
• Code C13005 (IP configuration reference) is set to ’0: Saved address’ to ensure that the
transferred address can be used.

Tip!
Check whether the configuration has been transferred successfully.
For this purpose, open the "Assign IP addresses" dialog window (see step 1) and click the
Find device button.