Lenze E82EV 8200 vector 0.25kW-2.2kW - Manual (Page 159)

Troubleshooting and fault elimination
Fault elimination
Fault messages
8
l
159 EDK82EV222 DE/EN/FR 13.0
Remedy Cause Fault PC 1) Keypad
ce6
a
67 System bus (CAN)
function module on
FIF has the
"Warning" or
"BUS−OFF" status
(configurable in
C0126) CAN controller reports "Warning"
or "BUS−OFF" status l Check bus termination
l Check shield connection of the
cables
l Check PE connection
l Check bus load, reduce the baud
rate, if necessary
ce7
a
68 Communication
error during remote
parameterisation
via system bus
(C0370)
(configurable in
C0126) Node does not respond or is not
available l Check bus termination
l Check shield connection of the
cables
l Check PE connection
l Check bus load, reduce the baud
rate, if necessary
For operation with application
I/O:
Parameter set change−over has
been parameterised incorrectly The "parameter set change−over"
signal (C0410/13, C0410/14) must be
connected to the same source in all
paramerter sets
EEr
a
91 External fault
(TRIP−SET) A digital signal assigned to the
TRIP−Set function is activated Check external encoder
ErP0
...
ErP19
a
− Communication
abort between
keypad and
standard device Various Contact Lenze
FAn1
a
95 Fan failure
(only 8200 motec
3 ... 7.5 kW)
TRIP or warning
configurable in
C0608 Fan is defective Replace fan
FAn1 − Fan is not connected Connect fan
Check wiring
H05
a
105 Internal fault Contact Lenze
id1
a
140 Faulty parameter
identification Motor is not connected Connect motor
LP1
a
32 Motor phase error
(display when
C0597 = 1) l Failure of one/several motor
phases
l Motor current is too low
l Check motor supply cables
l Check V min boost,
l Connect motor with a
corresponding power or adapt
motor with C0599
LP1 182 Motor phase error
(Display when
C0597 = 2)