MacDon M150 SP - Manual (Page 109)

HEADER OPERATION - A SERIES
Form 169017 / 169087 / 169095
107
Revision C
6.6.4 REEL SPEED
6.6.4.1 A40D Header
The A40 reel drive is hydraulically driven, and is
independent of the auger and knife speeds.
IMPORTANT
To prevent over-speeding the auger, initially
set the speed of the reel and auger as
follows: Subsequent adjustments to reel
speed do not affect auger speed.
Adjust the reel speed “on the go” as follows:
6.6.4.2 A30S and A30D Headers
The reel is driven by the auger, and both are
dependent on the main header drive speed. The
auger speed and hence the reel speed can be
changed by installing a different size auger drive
sprocket, or by varying the windrower engine rpm.
Display the reel speed as follows:
ENGAGE HEADER
HEADER INDEX
SWITCH - OFF
ON GSL PRESS SELECTOR BUTTON
OR SELECT SWITCH ON CDM FOR
##.## REEL RPM
##.## = 15.00 - 85.00
YES
##.## = 15.00 - 85.00
ENGAGE HEADER
HEADER INDEX
SWITCH - OFF
ON GSL PRESS SLOW
DISPLAY SHOWS
##.## REEL RPM
DONE
SPEED
15.00?
NO
YES
ON CDM PRESS SLOW OR
FAST ON AUGER SWITCH
DISPLAY SHOWS
##.# AUGER SPEED
NO
ON GSL PRESS SLOW OR
FAST
DISPLAY SHOWS
##.## REEL RPM
NO
YES
SPEED
OK?
##.# = 4.7 - 9.9
4.7 = 150 rpm
* 9.9 = 320 rpm
##.## = 15.00 - 85.00
SPEED
OK?
HEADER INDEX
SWITCH - OFF
DONE
ON GSL PRESS SLOW OR
FAST
DISPLAY SHOWS
##.## REEL RPM
NO
YES
SPEED
OK?
##.## = 15.00 - 85.00
DISPLAY
SELECTOR
DISPLAY
HEADER INDEX
FAST
SLOW
AUGER FAST /SLOW