MacDon M150 SP - Manual (Page 116)

HEADER OPERATION - R SERIES
Form 169017 / 169087 / 169095
114
Revision C
6.7.3 DISC SPEED
The header is allocated a code that the WCM
reads when the header is first attached to the
windrower, and the disc speed set-point
automatically becomes the minimum disc speed
for the header.
The operator can then program the desired speed
from the following table on the CDM to be stored
in the WCM memory, so that if the header is
detached and then re-attached to the windrower,
the disc will operate at the original set-point.
CROP CONDITION DISC RPM *
Alfalfa
Heavy 2100 - 2300
Light 1800 - 2000
Sudan,
Sorghum,
Haygrazer,
Timothy
Tall and
Stemmy
2300 - 2500
Short Grass
Dense 2500
Thin 2000 - 2200
* Suggested Overload Setting - 1300 rpm.
NOTE
Higher engine rpm may be required to
engage the R80 16 FT header. Do not
exceed 1800 rpm.
Display and set the desired disc speed as follows:
CAUTION
Check to be sure all bystanders have cleared
the area.
DISPLAY
SELECTOR
DISPLAY
HEADER INDEX
FAST
SLOW
XXX0 = RPM
ENGAGE HEADER
HEADER INDEX
SWITCH - OFF
ON GSL PRESS FAST OR
SLOW
DISPLAY SHOWS
XXX0 DISC RPM
DONE
SPEED
O.K.?
NO
YES