MacDon M150 SP - Manual (Page 126)

MAINTENANCE AND SERVICING
Form 169017 / 169087 / 169095
124
Revision C
7.6 LUBRICATING THE WINDROWER
WARNING
To avoid personal injury, before servicing
windrower or opening drive covers, follow
procedures in Section 7.1 PREPARATION
FOR SERVICING.
Recommended Lubricant
LUBRICANT SPEC DESCRIPTION USE
Grease
SAE
Multi-
Purpose
High Temp. Extreme
Pressure (EP2)
Performance With 1%
Max Molybdenum
Disulphide
(NLGI Grade 2)
Lithium Base
As Required
Unless
Otherwise
Specified
The greasing points are marked on the machine
by decals showing a grease gun and grease
interval in hours of operation. See illustration
below.
Log hours of operation and use the "Maintenance
Checklist" provided to keep a record of scheduled
maintenance. Refer to Section 7.14
MAINTENANCE SCHEDULE.
7.6.1 PROCEDURE
DANGER
Stop engine and remove key from ignition
before leaving Operator’s seat for any reason.
A child or even a pet could engage an idling
machine.
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
7.6.2 LUBRICATION POINTS
Refer to the illustrations on the following page to
identify the various locations that require
lubrication.