MacDon M150 SP - Manual (Page 92)

HEADER OPERATION - D SERIES
Form 169017 / 169087 / 169095
90
Revision C
3. Push down on rod end of link cylinder (K) until
hook engages pin on header and is locked.
4. Check that center-link is locked onto header
by pulling upward on rod end of cylinder.
HYDRAULIC LINK WITH OPTIONAL SELF-
ALIGNMENT KIT
1. Adjust the position of the center-link cylinder
with the REEL UP and REEL DOWN
switches, and HEADER TILT switches on the
GSL to position the hook above the header
attachment pin.
2. Lower the center-link onto the header with
REEL DOWN switch until it locks into position
(handle is down).
g. Raise the header fully with the HEADER UP
switch on the GSL. Stop engine and remove key.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
h. Engage lift cylinder stops on both lift cylinders.
Refer to Section 6.4.1 Header Lift Cylinder Stops.
i. Install pin (F) through header leg, (engaging U-
bracket in lift linkage) on both sides and secure
with hairpin.
j. Raise header stand (L) to storage position by
pulling pin (M), and lifting stand into uppermost
position. Release pin (M).
(continued next page)
L
M
F
K
HEADER TILT UP
HEADER
TILT DOWN
REEL UP REEL DOWN