MacDon M150 SP - Manual (Page 31)

OPERATOR’S STATION
Form 169017 / 169087 / 169095
29
Revision C
5.17 HEADER CONTROLS
All header controls are conveniently located on the
Operator’s console, and on the GSL handle.
NOTE
Some controls are optional equipment, and
may not be present in your unit. Some
controls may be installed, but will be non-
functional for certain headers.
5.17.1 HEADER ENGAGE SWITCH
Engages and disengages header drive.
IMPORTANT
Always move throttle lever back to idle
before engaging header drive. Do
not
engage header with engine at full RPM.
5.17.2 HEADER DRIVE REVERSE BUTTON
NOTE
The optional hydraulic reversing kit must be
installed.
IMPORTANT
To prevent improper operation and damage
to the reel on D Series draper headers
when the reverser kit is installed:
If switching between A40D auger header
and D50 or D60 draper header, the hose
plumbing to the reverser valve must be
changed to suit the header type. Refer to
Instruction Form #169213 that was supplied
with the reversing kit.
• Reverses knife and conditioner on D Series draper
headers.
• Reverses reel, auger, knife and conditioner on A
Series auger headers.
• Not applicable for R Series rotary headers.
NOTE
To re-engage header drive, push down, and
pull up header drive knob.
HEADER REVERSE
ENGAGE - Push / Hold / Engage Header
DISENGAGE - Release Button
HEADER DRIVE
ENGAGE - Push Center and Pull Up
DISENGAGE - Push Down