MacDon M150 SP - Manual (Page 186)

MAINTENANCE AND SERVICING
Form 169017 / 169087 / 169095
184
Revision C
7.11.2 HEADLIGHTS - ENGINE-FORWARD
DANGER
Stop engine, and remove key from ignition
before leaving Operator’s seat for any reason.
A child or even a pet could engage an idling
machine.
NOTE
Header should be attached and raised to
maintain proper windrower stance.
7.11.2.1 Alignment
a. Position windrower on level ground in front of a
vertical surface in accordance with the illustration.
b. Shutdown engine, and remove the key.
c. Turn on the headlights (A), and switch to low-
beam.
d. Align the headlights to the following specifications,
by turning adjusting screws (B).
• Adjustments are for low-beam.
• Light beams laterally centered on the
“direction of travel” line from the headlights
(i.e. not skewed left or right).
• Upper limit of the beam not higher than 49¾
inches (1263 mm) above ground, at a
distance of 25 ft. (7.5 m) from the headlight.
7.11.2.2 Bulb Replacement
a. Remove the two screws (C), and remove
headlight assembly from hood.
b. Pull wiring harness connector off the headlight
assembly, and remove rubber insulator boot (D).
(continued next page)
49.75 in.
(1263 mm)
maximum
C
D
B
A