MacDon M150 SP - Manual (Page 46)

OPERATOR’S STATION
Form 169017 / 169087 / 169095
44
Revision C
5.18.5 CAB DISPLAY MODULE (CDM)
PROGRAMMING
The monitoring system requires programming for
each header, and the
header must be attached
to the windrower so that the CDM recognizes the
type of header.
Programming the system may be accomplished
with or without the engine running. If the engine is
running, the transmission must be in neutral. If
the engine is not running, the ignition must be on.
Exit programming mode at any time by pressing
the PROGRAM switch, or by turning off the
ignition.
The system only needs to be programmed once
for each header. The operator may make
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine. Refer to Section 5.18.6 Setting
Guidelines for recommended settings. Most
functions have been pre-programmed at the
factory, but can be changed by the operator if
required.
Proceed as follows to program the CDM:
IMPORTANT
Header must be attached to the windrower
so that the CDM can detect the type of
Header (Header ID), and adjust the
programming mode accordingly. See
Sections 6.5, 6.6, and 6.7.
a. Turn ignition key to RUN, or start the engine.
Refer to Section 6.3.5 Engine Operation.
b. Press PROGRAM and SELECT on CDM to enter
programming mode. Header ID code is displayed.
c. Press SELECT. TRACTOR SETUP? is displayed
on upper line.
d. Press SET KNIFE SPEED? is displayed
e. Press or to change value on lower
line.
f. Press SELECT. KNIFE OVERLOAD SPD? is
displayed.
g. Press or to change value on lower
line.
h. Press SELECT. KNIFE OVERLOAD SPD? is
displayed.
i. Press or to change value on lower
line.
j. Press SELECT to advance to the next L1 item,
and press arrow keys to change values.
k. Press PROGRAM to exit programming mode
when finished entering desired values.
Refer to Detailed Programming Instructions on
following pages.
NOTE
Contact your Dealer for information
regarding software updates to the electronic
modules. Your MacDon Dealer will have
the necessary interface tools, and access to
the latest software upgrades.
* Fast scroll applies only when changing KNIFE SPEED, OVERLOAD PRESSURE, and TIRE SIZE.
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward
Keep Depressed For Fast Scroll *
MENU ITEM SCROLL FORWARD
Displays Value Under Menu Item
Push To Scroll Forward
Keep Depressed For Fast Scroll *
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line - Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor Into Program
Mode With PROGRAM SWITCH
Press to Accept Menu Item and
Advance to Next Item.
SIDE DISPLAY
Displays Software Revision Status
Upper Line - C### (CDM)
Lower Line - M### or T### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing SELECT Switch
Press To Exit Program Mode