MacDon M150 SP - Manual (Page 57)

WINDROWER OPERATION
Form 169017 / 169087 / 169095
55
Revision C
6.3.5 ENGINE OPERATION
6.3.5.1 Starting
DANGER
• Avoid possible injury or death from a
runaway machine.
• This machine has safety devices which
allow the engine to start only when the
ground speed lever is in N-DETENT, the
steering wheel is locked in the neutral
position, and the header drive switch is in
the OFF position. Under no circumstances
are these devices to be deliberately
rewired or misadjusted so that the engine
can be started with controls out of neutral.
• Do not start engine by shorting across
starter or starter relay terminals. Machine
will start with drive engaged and move if
normal starting circuitry is bypassed.
• Start engine only from Operator’s seat with
controls in neutral. NEVER start engine
while standing on ground. Never try to
start engine with someone under or near
machine.
• Before starting engine, be sure there is
plenty of ventilation to avoid asphyxiation.
IMPORTANT
Do not tow machine to start engine.
Damage to hydrostatic drives will result.
WARNING
Before starting engine, securely fasten your
seat belt and ensure trainer’s seat belt is
fastened if occupied. The seat belt can help
ensure your safety, if it is used and
maintained.
a. A battery main disconnect switch is located on the
RH frame rail, just behind the cab, and can be
easily accessed by raising the engine
compartment hood. Ensure switch is switched to
power on position.
b. Lock (A) must be engaged at cab-forward or
engine-forward position.
c. Move GSL (B) into N-DETENT.
d. Turn steering wheel until it locks. It may be
possible to move the steering wheel slightly in the
locked position.
IMPORTANT
Do not attempt to force the wheel out of
locked position as damage to the traction
system may occur.
e. Fasten seat belt.
f. Push header drive switch (C) to off.
(continued next page)
A
B
C