MacDon M150 SP - Manual (Page 163)

MAINTENANCE AND SERVICING - M200 ENGINE
Form 169017 / 169087 / 169095
161
Revision C
7.9.6 FUEL SYSTEM
7.9.6.1 Fuel Tank Venting
The fuel tank is vented by a hose that is
connected to the filler tube. The hose is
connected to a filter that should be changed
annually.
Change the filter as follows:
DANGER
Stop engine and remove key from ignition
before leaving Operator’s seat for any reason.
A child or even a pet could engage an idling
machine.
WARNING
To avoid personal injury or death from
explosion or fire, do not smoke or allow flame
or sparks near windrower when servicing.
a. Open engine compartment hood to highest
position.
b. Locate filter (A) on vent line against hydraulic oil
reservoir.
c. Release hose tension clamps (B), and slide away
from filter. Pull hoses off filter.
d. Position new filter through hole in frame, and
attach top hose onto filter. “IN” marking should
face down.
NOTE
If filter has an arrow instead of an IN
marking, arrow should point up.
e. Attach lower hose to filter, and secure both hoses
with tension clamps (B).
7.9.6.2 Fuel Filters
The M200 Windrower fuel system is equipped with
primary (C) and secondary (D) filters.
Both filters are screw-on cartridge type, but the
primary (C) filter is equipped with a separator that
separates sediment and water from the fuel.
(continued next page)
D C
B
A