MacDon M150 SP - Manual (Page 211)

MAINTENANCE AND SERVICING
Form 169017 / 169087 / 169095
209
Revision C
7.14.2 INTERVAL MAINTENANCE
INTERVAL SERVICE
FIRST USE Refer To BREAK-IN INSPECTIONS (previous page).
ANNUALLY *
1. Change Fuel Tank Vent Line Filter.
2. Check Battery Fluid Level.
3. Check Battery Charge.
4. Check
Antifreeze Concentration.
5. Cycle A/C Blower Switch To Distribute Refrigerant Oil.
6. Check Steering Control Rod Ball Joints.
END OF
SEASON
Refer To Section 6.3.9 Storage.
10 HOURS OR
DAILY
1. Check Tire Inflation.
2. Check Engine Oil Level.
3. Check Engine Coolant Level At Reserve Tank.
4. Clean Radiator, Hydraulic Oil Cooler, Charge Air Cooler, And A/C Condenser.
5. Check Hydraulic Oil Level.
6. Drain Fuel Filter Water Trap.
7. Fill Fuel Tank.
8. Check Hydraulic Hoses And Lines For Leaks.
50 HOURS
1. Grease Caster Pivots.
2. Grease Walking Beam Center Pivot.
3. Grease Top Lift Link Pivots.
4. Grease Forked Caster Spindle Bearings.
5. Clean Cab Fresh Air Intake Filter.
6. Check Gear Box Oil Level.
100 HOURS OR
ANNUALLY *
1. Clean Cab Air Return Filter.
200 HOURS OR
ANNUALLY *
1. Check Drive Wheel Lubricant Level.
2. Grease Formed Caster Wheel Hub Bearings.
3. Check Wheel Nut Torque.
500 HOURS
1. Change Engine Oil And Filter (or Annually).
2. Change Fuel Filters.
3. Change Gearbox Lubricant.
4. Change Hydraulic Oil Filters.
5. Check Engine Valve Tappet Clearance - Initial (M200 ONLY).
6. Change Engine Air Cleaner Filter Element (M200 ONLY).
7. Change Crankcase Breather (M200 ONLY).
8. Check Safety Systems (or Annually).
1000 HOURS
1. Change Engine Air Cleaner Filter Element (M150 ONLY).
2. Change Drive Wheel Lubricant
3. Check Engine Valve Tappet Clearance.
2000 HOURS
1. Change Hydraulic Oil.
2. Perform General Engine Inspection .
3. Change Engine Coolant (M150 ONLY).
3000 HOURS 1. Change Engine Coolant (M200 ONLY).
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING SEASON.